Freescale-semiconductor 56F8122 Manual do Utilizador Página 105
- Página / 137
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
DC Electrical Characteristics
56F8322 Technical Data, Rev. 10.0
Freescale Semiconductor 105
Preliminary
10.2.1 Voltage Regulator Specifications
The 56F8322/56F8122 have two on-chip regulators. One supplies the PLL and has no external pins;
therefore, it has no external characteristics which must be guaranteed (other than proper operation of the
device). The second regulator supplies approximately 2.6V to the device’s core logic. This regulator
requires two external 2.2µF, or greater, capacitors for proper operation. Ceramic and tantalum capacitors
tend to provide better performance tolerances. The output voltage can be measured directly on the V
CAP
pins. The specifications for this regulator are shown in Table 10-6.
Table 10-8 Current Consumption per Power Supply Pin (Typical)
On-Chip Regulator Disabled (OCR_DIS = High)
Mode
I
DD_Core
I
DD_IO
1
1. No Output Switching
I
DD_ADC
I
DD_OSC_PLL
Test Conditions
RUN1_MAC
110mA 13µA25mA 2.5mA
• 60MHz Device Clock
• All peripheral clocks are enabled
• Continuous MAC instructions with
fetches from Data RAM
• ADC powered on and clocked
Wait3
55mA 13µA35µA2.5mA
• 60MHz Device Clock
• All peripheral clocks are enabled
• ADC powered off
Stop1
700µA13µA0µA360µA
• 4MHz Device Clock
• All peripheral clocks are off
• Relaxation oscillator is on
• ADC powered off
• PLL powered off
Stop2
100µA13µA0µA145µA
• Relaxation oscillator is off
• All peripheral clocks are off
• ADC powered off
• PLL powered off
- 56F8322/56F8122 1
- Document Revision History 2
- IPBus Bridge (IPBB) 3
- Table of Contents 4
- Part 1 Overview 5
- 8KB of Data Flash 6
- 8KB of Data RAM 6
- 8KB of Boot Flash 6
- 1.2 Device Description 7
- 1.2.2 56F8122 Features 8
- Freescale Semiconductor 9 9
- 16 bits 10
- To/From IPBus Bridge 11
- Table 1-2 Bus Signal Names 12
- 1.5 Product Documentation 13
- 1.6 Data Sheet Conventions 13
- 2.1 Introduction 14
- Freescale Semiconductor 15 15
- 16 Freescale Semiconductor 16
- 2.2 Signal Pins 17
- Signal Pins 19
- 3.1 Introduction 26
- 3.2.3 External Clock Source 27
- 28 Freescale Semiconductor 28
- 3.5 Registers 29
- Part 4 Memory Map 30
- 4.3 Interrupt Vector Table 31
- (Continued) 32
- 4.4 Data Map 34
- 4.5 Flash Memory Map 34
- Flash Memory Map 35
- 4.6 EOnCE Memory Map 36
- (TMRA_BASE = $00 F040) 37
- (TMRC_BASE = $00 F0C0) 39
- (PWMA_BASE = $00 F140) 40
- (DEC0_BASE = $00 F180) 41
- (ITCN_BASE = $00 F1A0) 41
- (ADCA_BASE = $00 F200) 42
- Register Description 44
- (FM_BASE = $00 F400) 47
- (FC_BASE = $00 F800) 47
- 5.1 Introduction 52
- 5.2 Features 52
- 5.3 Functional Description 52
- Functional Description 53
- 5.4 Block Diagram 54
- 5.5 Operating Modes 54
- 5.6 Register Descriptions 55
- 56 Freescale Semiconductor 56
- Freescale Semiconductor 57 57
- 58 Freescale Semiconductor 58
- Freescale Semiconductor 59 59
- 60 Freescale Semiconductor 60
- Freescale Semiconductor 61 61
- 62 Freescale Semiconductor 62
- Bits 11–10 63
- 64 Freescale Semiconductor 64
- Freescale Semiconductor 65 65
- Bits 15–14 66
- 5.6.8.2 Reserved—Bits 13–6 66
- Freescale Semiconductor 67 67
- 68 Freescale Semiconductor 68
- Freescale Semiconductor 69 69
- 70 Freescale Semiconductor 70
- 5.6.12.1 Reserved—Bits 15–7 71
- 5.6.14.1 Reserved—Bits 15–5 71
- 5.6.15.1 Reserved—Bits 15–7 72
- 5.6.17.1 Reserved—Bits 15–5 73
- 5.6.18.2 Reserved—Bit 0 73
- 74 Freescale Semiconductor 74
- Freescale Semiconductor 75 75
- 76 Freescale Semiconductor 76
- 5.7 Resets 77
- 6.1 Introduction 77
- 6.2 Features 78
- 6.3 Operating Modes 78
- 6.4 Operating Mode Register 79
- 6.5 Register Descriptions 79
- 6.5.1.1 Reserved—Bits 15–6 80
- Freescale Semiconductor 81 81
- 6.5.2.6 Reserved—Bits 1–0 82
- 6.5.6.1 Reserved—Bits 15–12 83
- 6.5.6.2 RESET—Bit 11 83
- Figure 3-4) 84
- 6.5.7.5 HOME0 (HOME)—Bit 6 85
- 6.5.8.1 Reserved—Bits 15–8 86
- 6.5.8.2 GPIO C6 (C6)—Bit 7 86
- 6.5.8.3 GPIOC5 (C5)—Bit 6 86
- Freescale Semiconductor 87 87
- 88 Freescale Semiconductor 88
- Freescale Semiconductor 89 89
- 1 1 1 1 1 1 1 1 1 1 1 1 1 1 90
- ISAL[23:22] 90
- 111111 1 11111 1 1 11 90
- ISAL[21:6] 90
- 6.7 Power-Down Modes 91
- 6.9 Resets 92
- Part 7 Security Features 93
- 7.2.3 Flash Lockout Recovery 94
- << 95
- 8.1 Introduction 96
- 8.2 Configuration 96
- Configuration 97
- 8.3 Memory Maps 98
- 9.1 JTAG Information 98
- Part 10 Specifications 99
- Comments Symbol 101
- Unit Notes 101
- 1. No Output Switching 105
- Table 10-10. PLL Parameters 106
- 10.2.2 Temperature Sense 107
- Figure 10-2 Signal States 108
- External 109
- 10.7 Oscillator Parameters 110
- Oscillator Parameters 111
- First Fetch 113
- Not IRQA Interrupt Vector 114
- First Instruction Fetch 114
- Table 10-18 SPI Timing 115
- 10.10 Quad Timer Timing 118
- Figure 10-15 RXD Pulse Width 119
- Figure 10-16 TXD Pulse Width 119
- Table 10-21 SCI Timing 119
- 10.14 JTAG Timing 120
- JTAG Timing 121
- Table 10-24 ADC Parameters 122
- 124 Freescale Semiconductor 124
- Preliminary 124
- 10.17 Power Consumption 125
- • Cload is expressed in pF 126
- Freescale 127
- Freescale Semiconductor 131 131
- 132 Freescale Semiconductor 132
- Freescale Semiconductor 133 133
- DDA_OSC_PLL 134
- Part 13 Ordering Information 135
- How to Reach Us: 136
Manuais e produtos relacionados com Hardware Freescale-semiconductor 56F8122
(24 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.310 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais